Router Table Extension

 Why do most table saws have an extensions on them but you very  seldom see an extension of a router table or shaper cutter? A small  table top on a router table makes it very difficult to manage a larger or  longer workpiece often making it unsafe as well.  Router table tops  need to be large enough to support your work.  This is the same  reason extensions are added to table saws.  If you are building your  own router table, don't settle for the normal sized table.  Add an extension similar to the router table in the picture or design your own.  It's much more important to have the additional surface space on the in-feed side of the table than the out-feed side.  For better utilization of the extra table top space, an additional router plate was installed in this table.  If you have a certain round over bit that you constantly use and an extra router available, it is very quick and easy to mount it to the extra plate and drop it in the extension part when you need it.  Having an extra blank plate to fill in the hole when the router is not needed will keep you form having to adjust the extra router up and down as well.

Leave your comment

Comments have to be approved before showing up